Traeger Ler Error Fix
If your Traeger’s digital display shows an ERR error code, it’s important to know what’s causing the problem. This code can indicate a defective or broken part inside the controller, probe, or other internal part. If you can’t determine what’s causing the error, you should contact Traeger customer service to see if they can repair the unit.
The first step in determining the cause of this error is to determine the cause of the low error temperature. Often, this error code is triggered when the grill temperature drops below 125 degrees Fahrenheit for ten minutes. The problem could also be caused by debris that prevents proper ventilation.
If the problem persists, you might want to replace the temperature probe. The temperature probe is attached to the controller by two wires. If the wires are loose or disconnected, tighten them. If that doesn’t fix the problem, try buying a new temperature probe from an online retailer. After replacing the probe, check the temperature again to see if the error has been resolved. If not, you can always contact Traeger support to see if the problem is related to the temperature probe.
The LEr error is a frustrating problem, but it doesn’t have to be permanent. With the right steps, you can fix the LEr code on your Traeger pellet grill. This will allow you to cook your food longer and more evenly. You’ll have higher-quality grilled foods with fewer flare-ups.
The HEr error code is caused by the Traeger’s temperature fluctuating by 25 degrees during the grilling process. This means the grill temperature has exceeded the preset temperature for 45 seconds. The LEr error code, meanwhile, occurs when the temperature has exceeded 120 degrees for 10 minutes.
Besides replacing the grill itself, there are also a number of other troubleshooting steps that can be taken to fix the LEr error on a Traeger. One of the most common and simple steps involves cleaning the fire pot, which is crucial to prevent excessive heat and increase the cooking time. It is also important to check the heat diffuser and drip pan to see if they are damaged.
Changing the temperature probe and controller is another possible solution. Ensure that the temperature probe is clean and free of debris. You can contact Traeger support to get a replacement RTD probe or a new controller. There are some videos that can show you how to clean the temperature probe and replace the controller.
Also Read:Write For Us
If you’ve tried all the above but have still been unable to resolve the problem, the temperature controller is probably the problem. The controller is held in place by two screws. Remove it and make sure that you’ve unplugged the Traeger first. If the problem persists, replace the temperature probe with a new one.
